Interphase-tech RAS Communications Controller 5536 Instrukcja Użytkownika Strona 186

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 185
Setting Port and Clock Modes
166 Interphase Corporation
Loopback Mode
Loopback mode is a transmission state in which the signal
received by the port is returned to the sender. Use this mode
when the remote end (the Telco, for example) is testing your
line; all information sent is returned to the remote end.
Two loopback settings are available:
Line loopback—The signal returned to the loopback
command source consists of the full signal. Bit
sequence integrity is maintained. No change in framing
occurs, and no bipolar violations are removed. This is
the default loopback setting.
Payload loopback—The signal returned to the loopback
command source consists of the payload of the received
signal and newly-generated ESF framing.
To change the default loopback mode setting:
1. Select Loopback mode on the Port Test Configuration
dialog box (shown in Figure D-2 on page 165).
2. Click Options on the Line Test Configuration dialog
box.
The Port Options dialog box appears:
Przeglądanie stron 185
1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 243 244

Komentarze do niniejszej Instrukcji

Brak uwag